JDS Multimedia

4th
JUL

Secrets of Ribbon Fiber

Posted by admin under Technology

Do you know why it is so expensive to install Fiber To The Home? Why the Bell companies are reluctant to provide fiber optic network directly to consumers on a large scale?

This is not the cost of materials. It is the job! The introduction of fiber in the Subscriber Loop, the installation of short lengths of cable with a large number of splicing. The speed with which the cables, edges, accessible and reconfigured are always extremely important.

Hence the need for new technologies, the promise of reducing the use of fibre costs are very high. Bell are concerned about the acquisition of these new technologies and products in order to reduce costs and grow broadband fiber optic network installation.

This is where the high fibre count tablecloth come to play. This compact, UV-epoxy cables are included with fibre-optic high-precision and can be restricted to the edges of a merger with a minimum loss. These products have been an excellent platform for FTTH.

Épissage mass concentrations of Japanese machines are an integral part of this process. The merger role changer technician installing the fiber cliver up to 24 fibers over a period of very low loss cliver.

Ribbon Fiber-Design

The basic requirement for each optical fiber cable design is the protection of fiberglass inside harsh environments. But for the ribbon fiber, it is the other key condition: the organization of fiber for better efficiency in the use of space and ease of splicing fusion mass and handling. And in the same, it must also performance optical and mechanical reliability.

This means that the ribbon of light must be responsible for the high number of pieces of fiberglass, fibre exactly to organize mass production Fusion Splicing, the individual identification of fibre, it can be different sub-assemblies or fiber , Mechanical reliable and easily accessible from the end or midspan.

These requirements must be met at the same time making the manufacture of high quality fibres, a tape lasts task.

It is a fibre-optic cable specialists have an excellent design. An array of fiber colors stuck on a coating line of fiberglass materials. Based on this basic structure, two design: glued or sealed board.

Edge Design Bonded

The board design borrowings stuck at the bottom, fibres, which only between the materials in each fiber. This design is more popular in the USA. This design is 40% smaller than the chip design.

Capsules Design

Encapsuler in the design, collage materials well beyond the gaps between the fibres, in fact, it encapsulates all fibres in a rectangular tube. This design is most commonly used in Japan.

Ribbon Fiber mass merger Épissage

The gain time for the ribbon fiber mass fusion splicing are so large that sometimes in some fibres are ribbonlized ashore splicings merger.

But the success of the mass of the ribbon fiber Épissage criticism is based on the geometry of fiberglass, the tape and the role of mass changer merger. High quality and consistency of concentrations of mass splice can be made with bands from fibres with strict geometric tolerances.